Installation Steps
A quick and hassle-free installation process designed to get you back on the road fast.
-
OBD2 Port
Locate your vehicle’s OBD2 port. It is usually located under the dashboard on the driver’s side. Do not plug the module in yet.
-
Ignition
Put the vehicle in Accessory mode.
-
Plug In
Connect AutoByte to your vehicle’s OBD2 port while the car is running.
-
Drive & Calibrate
Drive 50–150 miles to allow AutoByte to calibrate. Once calibrated, you’ll notice the difference.
Notes & Tips
Keep these essential tips in mind for the best results.
-
Installation Guide
The AutoByte module must stay plugged in to work. If you remove it, you will need to drive 50–150 miles again for it to recalibrate.
-
Emissions Testing
If you have an emissions test, simply remove the product for testing, then plug it back in afterward.
-
LED Indicator
The LEDs on the chip will not change at any point, as long as they are illuminated the chip is working properly. If you see no LED lights, please contact us.
-
Higher-Octane Fuel
Higher-octane fuel can increase the benefits of AutoByte, but it is not required.
-
Returns to Stock
When you remove AutoByte, your car returns to stock settings with no memory or footprint.
Accessory Mode Guide
How to put your push-to-start vehicle in accessory mode
-
01 Step
Foot Off the Brake
Ensure your foot is completely off the brake pedal.
-
02 Step
First Press
Press the Start/Stop button once to activate the radio and dashboard.
-
03 Step
Second Press
Press it a second time for full dashboard power (Run mode).
-
04 Step
Third Press
Press it a third time to turn it off.
To put a push-to-start car in accessory mode, ensure your foot is completely off the brake pedal. Press the start/stop button once to activate the radio and dashboard. Press it a second time for full dashboard power (Run mode), and a third time to turn it off.
-
Simple Setup
Easy to install and use.
-
Plug-and-Play
No wiring. No hassle.
-
Reliable Performance
Engineered for dependability.
-
Quick Reference
Keep this guide handy.